TOPIC:

I use two frequencies which are outside the ham bands. How do I configure AG to select a specific antenna when using these frequencies? I am using a Flexradio 6600M, and the 8x2 switch. For instance I use the iOS SSDR program to operate the radio. The frequency of interest is a 3.3 MHz, I set the band information for 80 meters as 3.5 to 4.0 MHz and make a custom band of 3.2 to 3.4 for my special frequency and antenna. I expect that when I operate on 80 my vertical is selected and when on the out of band frequency a dipole to be selected. This doesn’t happen. If I open the AG app, both antennas are available but it doesn’t select the dipole. What am I doing wrong?

73,
Steve KD2OM

Hi Steve,

Would you be so kind to provide a screenshot of your antenna/bands settings?

Regards,

Here they are. Thank you

It seems that "General" is making problems.
Please put it as the last item in the band configuration.

AG gets freq information from Flex, and chooses the first band it finds with that freq. In your case -- it was General.
In Windows App, in upper left hand corner, you will see "LAN/General".

If you put "General" at the bottom of band list, when you choose 3345 kHz in Flex AG will select the Dipole antenna, and in upper left hand corner of application you will read LAN/FRE1.

Thank you Dragan, that worked fine. I figured it was something I was doing wrong.

73
Steve KD2OM

Thank you, Steve. Enjoy in radio.
73