TOPIC:

Been using my Flex 6700 with the 8 port AG for a few years... works great!! Now I loaded Flex V3 and remote computer works fine but the AG on the remote does not follow the Flex.....What am I missing?? To make either station control the AG I must first set the station to the same band as the other station and the the AG will follow and the other station must do the same same thing before they transmit before the AG will reset and follow them... rather slaw and complicated

Hello AH0U,

It should work fine - what version of AG sofware are you using?
Can you send some screenshots of your configuration / connection to Flex?

I am using ver 3.1.4 of the AG software and ver 3.1.12 on my Flex 6700.. the problem is if I TX on the laptop on RX 1 with the AG set to 40 meters and the TX1 set to 40 meters it works fine now if I go to the desktop computer with RX1 set to say 20 meters and transmit, the AG stays on 40 meters unless I re-click on the red TX button turning it off and then on again so the AG will follow... If I were not in the shack watching but at the remote site with the laptop, I WOULD THINK i was on the correct antenna... teh AG does not follow the computer being used.

Hi Bruce,


AG is ALWAYS following TX antenna. If it is selected on 40, and it is regardless where you are listening, AG will stay on 40.


73
Ranko

In my case it does not follow... with the desk top SmartSDR TX on 20 and the AG On 20 and the laptop on 40.. when I TX on the laptop on 40 the AG stays on 20.. it dies not follow the TX on 40.. to make it follow I must click off TX on the laptop the. re click on TX on the laptop to make it follow... when operating remotely or away. From the desktop I never know if the antenna is on the correct band or not... not very helpful