TOPIC:

Hi

I install version 3.0 of the firmware but it keeps saying to update it. Here I made a video.

Please use newer version of AG firmware.
It is located in the same folder where windows installation is.
It should be 3.1.14 version, so far.

By default, it is in: C:\Program Files (x86)\4O3A Signature\Antenna Genius.
However, your mileage may vary.

TNX Dragan

Now I am local to the station B computer. Since the station A computer does not work. In the video you can see that in Configure Flexradios the Flex does not appear on the devices. I put manual the serial number.

I connected the Flex 6500 and it is recognized by the Antenna Switch. But the Flex 6400 doesn't recognize it.

Any advice on this? Thanks

I didn't see very well what mode did you choose at start of AG software, was it SO2R? In previous video I saw that you were choosing Radio B.
What happens if you choose SO2R?

From AG configuration, I see that you properly configured two radios.
Radios are assigned to two ports, but also to two antennas.
Did you properly choose your antenna for 6400? Should it be ANT1 or ANT2?

Regards,

Hi

I put the 6400 in Ant 1 as well as 6500 and now is working well. I have the 6500 in Port A & Ant 1 and the 6400 in Port B & Ant 1 as well.