Manual Antenna Controller S8 is an accessory in use with Antenna Genius, Antenna Switch 8x2 or Splitter PS3000RX.

Our rotary base comes with a preinstalled motor. You can choose between a single phase and three phase motor.

Height: 4U, Width: 19"

N-type connector 90°, for 5 mm cables. PTFE insulation.

(RG-58, RG-142...)

NC-1 features Bluetooth 5.0 connectivity. In case your computer does not have Bluetooth capability we offer a verified tested dongle.

BTNC1 is designed for normal use within the same room.

This dongle does not come standard with the NC-1 headset.

The PG-M VHF 642 is a state-of-the art VHF linear power amplifier that covers 50MHz, 70MHz and 144MHz bands and provides 1000 W output power (PEP or continuous carrier) with less than 50W of drive.

Optimize your antenna performance with the TGXL-O, a groundbreaking LAN-controlled automatic antenna tuner designed for installation directly at your antenna feed point – the ideal location for a tuner.

OM module features 16 dual output relays and can be used with either the Antenna Genius 8x2, 8x1 or the Station Genius controller.

Towers are usually designed with 3m or 6m long sections, with standard width of 50cm, 60cm, 65cm, 80cm or 100cm.

This interface will convert frequency data given from RS232 CAT or CI-V to BCD output. BCD output can be used to control Antenna Genius or any other BCD controlled device.

N-type connector 90°, for 10 mm cables.
PTFE insulation.

(RG-213,RG-214...)

The soft casing for transporting your MC-1 microphone as well as protecting it in storage.

This soft case comes standard with the MC-1 Microphone.

The revolutionary TWIN topology offers ultimate flexibility for your radio station, transforming with a press of a button to match your desired configuration.
Combine the two modules into a single powerful amplifier, delivering 3500 watts of power in SO2R configuration.

A high isolation 6 antenna to 1 radio outdoor switch, with built- in high power CMC transformer, that can be safely installed at the bottom of your tower.

High isolation A to B switch, need for some applications such as extension of the antenna matrix.

N-type connector, for 10 mm cables.
PTFE insulation.

(RG-213, RG-214...)

The soft casing for transporting your NC-1 headset as well as protecting it in storage.

The first 4O3A commercial amplifier. Continuous frequency coverage from 1 to 30MHz. Our TWIN topology provides guaranteed uptime through redundancy.If one out of the two RF modules fails for whatever reason, the amplifier will still remain on air uninterrupted, keeping half power through the second RF module. The damaged module can be hot swapped with a new one with absolutely no downtime.

The A50 switch is used as the 50 Ohm load for open ports on the HFC3000 combiner to prevent tuning degradation.

PL plug, for 5 mm cables, 90° angle.
PTFE insulation.

(RG-58, RG-142…)